jaemad.blogg.se - How to install hondata s300

#How to install hondata s300 serial
#How to install hondata s300 software
#How to install hondata s300 Bluetooth

The s300 has datalogging to the SManager software built in via the USB or Bluetooth.

#How to install hondata s300 Bluetooth

No EPROM programmer is necessary - you just need a laptop with USB port or Bluetooth capability. The s300 does not use an EEPROM or equivalent, so you never need to open the ECU to change chips nor 'burn' ROMs. Changes made in the SManager softwareare uploaded to the ECU instantly and you can see the effect immediately. This means that calibrations and changes can be uploaded to the ECU very quickly (2 seconds for a new calibration, a fraction of a second for anything else), without interrupting the operation of the engine. The s300 can be updated in real-time with the engine running without affecting the operation of the vehicle.

Three general purpose outputs for nitrous control, quad boost control or similar.

Fuel and ignition correction based on gear.

Adjustable boost cut with hot and cold settings.

Adjustable VTEC window with load and throttle control.Rev limiter with fuel cut or fuel and ignition cut.Fuel trim for starting, throttle tip in and individual cylinder trim.High and low speed 24 x 20 ignition and fuel tables for correct VTEC tuning.Two analog inputs for wideband, EGTs etc.Dual tables for high/low octane calibrations etc.PWM output for boost control with fixed or gear based boost.Supports lambda tracing from a wideband o2 (PLX wideband recommended).Three multi purpose outputs for nitrous control or similar.

Expanded fuel and ignition tables to 60 + lbs boost and 11,000 + rpm.

Configurable for any MAP sensor (to 5 Bar and above).

Adjustment for different sized injectors, with overall fuel trim.

On board datalogging memory (8 MB memory, 20-240 minutes datalogging) with trigger conditions.

Built in calibrations for common engine combinations.

Real-time updating of ECU parameters & tables.

#How to install hondata s300 software

SManager Windows based software for parameter & table editing, calibration uploading and datalogging.

USB and Bluetooth connection for speed and compatibility.

Non battery memory backup for greater reliability and longer life.

Datalogging memory doubled in size for up to 2 hours recording.

Additional security to help identify and prevent theft.

#How to install hondata s300 serial

Serial output for dashboards like the AiM MXL and Racepak IQ3 - (needs 230-vmefi-hond).

Bluetooth for laptop programming/datalogging and mobile datalogging.

Forced induction, datalogging, real time programming, Bluetooth and engine protection are but a few of the comprehensive s300 features. The s300 version 3 is a plug in module to the OBD1 factory Honda Engine Computer (not included) which vastly expands the capabilities of the factory ECU. Protect yourself from purchasing counterfeits, buy genuine Hondata products from Revzone - an authorised Hondata dealer in Australia Print out and fill in the Installation Form (include this form with the ECU) and invoice.Contact Revzone (03 9870 0540 or book your ECU for installation ($110 installation fee).Hondata S300 (Rectangular Frame ECU) Version 3 (V3) Hondata installations